LIRC

LIRC integration for Home Assistant allows you to receive signals from an infrared remote control and control actions based on the buttons you press. You can use them to set scenes or trigger any other automation.

Sending IR commands is not supported in this component (yet), but can be accomplished using the shell_command component in conjunction with the irsend command.

Installation

To allow Home Assistant to talk to your IR receiver, you need to first make sure you have the correct dependencies installed:

$ sudo apt-get install lirc

If you are configuring on a Raspberry Pi, there are excellent instructions with GPIO schematics and driver configurations here. Consider following these.

Configuring LIRC

Now teach LIRC about your particular remote control by preparing a lircd configuration file (/etc/lirc/lircd.conf). Search the LIRC remote database for your model. If you can’t find it, then you can always use the irrecord program to learn your remote. This will create a valid configuration file. Add as many remotes as you want by pasting them into the file. If irrecord doesn’t work (e.g. for some air conditioner remotes), then the mode2 program is capable of reading the codes in raw mode, followed by irrecord -a to extract hex codes.

Next, you have to make a ~/.lircrc file that maps keypresses to system actions. The configuration is a bit tedious but it must be done. Use the prog = home-assistant for all keys you want to be recognized by Home Assistant. The values you set for button must be the same as in the lircd.conf file and the values you put for config entry will be the sensor value in Home Assistant when you press the button. An example may look like this:

begin
    remote = SONY
    button = KEY_1
    prog   = home-assistant
    config = KEY_1
end
begin
    remote = SONY
    button = KEY_2
    prog   = home-assistant
    config = KEY_2
end
begin
    remote = SONY
    button = KEY_3
    prog   = home-assistant
    config = KEY_3
end

Test your LIRC installation before proceeding by running:

$ irexec -n home-assistant

and pressing some buttons on the remote.

Configuration Home Assistant

# Example configuration.yaml entry
lirc:

If you are on a Debian based system (like Raspberry Pi) and are having issues loading the component due to it being unable to install python-lirc, install it manually using apt-get install python3-lirc.

Events

The LIRC component fires ir_command_received events on the bus. You can capture the events and respond to them in automation scripts like this:

# Example configuration.yaml automation entry
automation:
- alias: Off on Remote
  trigger:
    platform: event
    event_type: ir_command_received
    event_data:
      button_name: KEY_0
  action:
    service: homeassistant.turn_off
    entity_id: group.a_lights

The button_name data values (e.g. KEY_0) are set by you in the .lircrc file.