HASSbian documentation (#3063)

* Remove Hassbian

* Replace Hassbian with Hass.io

* Move Hassbian docs to installation folder

* Update navigation

* Update redirects

* Update link

source/_docs/installation/hassbian/integrations.markdown

@@ -0,0 +1,56 @@
+---
+layout: page
+title: "Raspberry Pi integrations"
+description: "Home Assistant integrations specific to the Raspberry Pi."
+date: 2016-09-26 21:00
+sidebar: true
+comments: false
+sharing: true
+footer: true
+redirect_from: /docs/hassbian/integrations/
+---
+
+Some components that are specific for the Raspberry Pi can require some further configuration outside of Home Assistant. All commands below are assumed to be executed with the `pi` account. For full documentation of these components refer to the [components](/components) page.
+
+### {% linkable_title Bluetooth Tracker %}
+
+The Bluetooth tracker will work on a Raspberry Pi 3 with the built-in Bluetooth module or with a USB Bluetooth device on any of the other Raspberry Pi's.
+
+Software needed for the tracker is pre-installed so just follow the [Bluetooth Tracker component](/components/device_tracker.bluetooth_tracker/) and [Device Tracker page](/components/device_tracker/) pages.
+
+### {% linkable_title Raspberry Pi GPIO %}
+
+Each of the following devices are connected to the GPIO pins on the Raspberry Pi.
+For more details about the GPIO layout, visit the [documentation](https://www.raspberrypi.org/documentation/usage/gpio/) from the Raspberry Pi foundation.
+
+Permission have been given to the `homeassistant` user to use the GPIO pins and all of the following components should require no underlying changes to work.
+Just follow the component pages for each on how to add them to your Home Assistant installation.
+
+ - [DHT Sensor](/components/sensor.dht/).
+ - [Raspberry Pi Cover](/components/cover.rpi_gpio/).
+ - [Raspberry PI GPIO Binary Sensor](/components/binary_sensor.rpi_gpio/).
+ - [Raspberry PI GPIO Switch](/components/switch.rpi_gpio/).
+ - [Raspberry Pi RF Switch](/components/switch.rpi_rf/).
+
+### {% linkable_title Raspberry Pi Camera %}
+
+The Raspberry Pi Camera is a specific camera for the Raspberry Pi boards. For more information about the camera I suggest reading the [documentation](https://www.raspberrypi.org/documentation/usage/camera/) from the Raspberry Pi foundation.
+
+To use the camera it needs to be enabled with the `raspi-config` utility.
+
+```bash
+$ sudo raspi-config
+```
+
+Go to `Interfacing Options`, select `Enable camera` choose `<Yes>` and hit `Enter`, then go to `Finish` and you'll be prompted to reboot.
+
+After this follow the [Raspberry Pi Camera component](/components/camera.rpi_camera/) page.
+
+### {% linkable_title One wire Sensor %}
+
+The One wire sensor requires that support for it is enabled on the Raspberry Pi and that the One Wire device is connected to GPIO pin 4.
+To enable One Wire support add the following line to the end of `/boot/config.txt`
+```yaml
+dtoverlay=w1-gpio
+```
+After this follow the [One Wire Sensor component](/components/sensor.onewire/) page.